Non Ferrous Saw Blades


Thick Walled Saw Blades 
The special carbide formulation and blade geometry makes this blade ideal for cutting aluminum and non-ferrous metal bars such as copper, brass, bronze and lead. Also, good for cutting relatively thick-walled extrusions and profiles. The negative hook angle, triple-chip grind and thick plate combine to produce a superior finish. Use as coolant or blade wax and clamp down the work piece when cutting non-ferrous metals. The blade can be used to cut other “difficult” materials such as plastic, PVC tubing and fiberglass.

Thin Walled Saw Blades 

Designed specifically for cutting relatively thin-walled aluminum and non-ferrous extrusions and frames. Use a coolant or blade wax and clamp down the work piece when cutting non-ferrous metals. 

Warning: NEVER attempt to cut ferrous metals (steel, iron, etc.) with these saw blades. Non-Ferrous blade is not to be used on multi-purpose cut-off saws or gas power saws, unless saw has a guard that covers both the upper half an d the lower half of the blade completely. The guard must extend to the lowest point of the cutting teeth on the bottom of the blade. Consult machine owner’s manual and follow all instructions and safety procedures - including wearing safety goggles at all times while working with this blade. NOTE: Due to the rough applications for which these blades may be used, they are not guaranteed. 

Page:
  1. 1
  2. 2

Page:
  1. 1
  2. 2

Back to top